Syslog log source parameters for Cisco CatOS for Catalyst Switches

If QRadar does not automatically detect the log source, add a Cisco CatOS for Catalyst Switches log source on the QRadar Console by using the syslog protocol.

When using the syslog protocol, there are specific parameters that you must use.

The following table describes the parameters that require specific values to collect syslog events from Cisco CatOS for Catalyst Switches:

Table 1. Syslog log source parameters for the Cisco CatOS for Catalyst Switches DSM
Parameter	Value
Log Source type	Cisco CatOS for Catalyst Switches
Protocol Configuration	Syslog
Log Source Identifier	Type the IP address or host name for the log source. The identifier helps you determine which events came from your Cisco CatOS for Catalyst Switch device.