OPSEC/LEA log source parameters for Check Point

If QRadar® does not automatically detect the log source, add a Check Point log source on the QRadar Console by using the OPSEC/LEA protocol.

When using the OPSEC/LEA protocol, there are specific parameters that you must use.

The following table describes the parameters that require specific values to collect OPSEC/LEA events from Check Point:

Table 1. OPSEC/LEA log source parameters for the Check Point DSM
Parameter	Value
Log Source type	Check Point
Protocol Configuration	OPSEC/LEA
Log Source Identifier	Type the IP address or host name for the log source as an identifier for events from your Check Point devices.

For a complete list of OPSEC/LEA protocol parameters and their values, see OPSEC/LEA protocol configuration options.