SNMPv2 log source parameters for Cisco Wireless LAN Controllers

If QRadar® does not automatically detect the log source, add a Cisco Wireless LAN Controller log source on the QRadar Console by using the SNMPv2 protocol.

The following table describes the parameters that require specific values to collect SNMPv2 events from Cisco Wireless LAN Controllers:

Table 1. SNMPv2 log source parameters for the Cisco Wireless LAN Controller DSM
Parameter	Value
Log Source type	Cisco Wireless LAN Controllers
Protocol Configuration	SNMPv2
Log Source Identifier	Type the IP address or host name for the log source. The identifier helps you determine which events came from your Cisco Wireless LAN Controller.
Community	Type the SNMP community name that is needed to access the system that contains the SNMP events. The default is Public.
Include OIDs in Event Payload	Select the Include OIDs in Event Payload check box. This option allows the SNMP event payload to be constructed by using name-value pairs instead of the standard event payload format. OIDs in the event payload are needed to process SNMPv2 or SNMPv3 events from certain DSMs.
Enabled	Select the Enabled check box to enable the log source. By default, the check box is selected.
Credibility	From the list, select the credibility of the log source. The range is 0 - 10. The credibility indicates the integrity of an event or offense as determined by the credibility rating from the source devices. Credibility increases if multiple sources report the same event. The default is 5.
Target Event Collector	From the list, select the Target Event Collector to use as the target for the log source.
Coalescing Events	Select this check box to enable the log source to coalesce (bundle) events. Automatically discovered log sources use the default value that is configured in the Coalescing Events drop-down in the QRadar Settings window on the Admin tab. However, when you create a new log source or update the configuration for an automatically discovered log source, you can override the default value by configuring this check box for each log source.
Store Event Payload	Select this check box to enable or disable QRadar from storing the event payload. Automatically discovered log sources use the default value from the Store Event Payload drop-down in the QRadar Settings window on the Admin tab. However, when you create a new log source or update the configuration for an automatically discovered log source, you can override the default value by configuring this check box for each log source.

For a complete list of SNMPv2 protocol parameters and their values, see SNMPv2 protocol configuration options.