Syslog log source parameters for Cisco ACS v5.x

If QRadar® does not automatically detect the log source, add a Cisco ACS v5.x log source on the QRadar Console by using the syslog protocol.

When using the syslog protocol, there are specific parameters that you must use.

The following table describes the parameters that require specific values to collect syslog events from Cisco ACS v5.x:
Table 1. Syslog log source parameters for the Cisco ACS DSM
Parameter Value
Log Source type Cisco ACS
Protocol Configuration Syslog
Log Source Identifier Type the IP address or hostname for the log source.

The identifier helps you determine which events came from your Cisco ACS appliance.