IBM®
QRadar® Risk Manager supports the HP Networking ProVision adapter.
The following features are available with the HP Networking ProVision adapter:
- Neighbor data support
- SNMP discovery
- RIP dynamic routing
- Telnet and SSH connection protocols
The following table describes the integration requirements for
the HP Networking ProVision adapter.
Table 1. Integration requirements for the HP Networking ProVision
adapter
| Integration requirement |
Description |
|
Versions
|
HP Networking ProVision Switches K/KA.15.X
Restriction:
HP switches that run a Comware operating system are not supported by this adapter.
|
|
SNMP discovery
|
Matches version numbers with the format HP(.*)Switch(.*)(revision
[A-Z]{1,2}\.(\d+)\.(\d+)) in sysDescr.
|
|
Required credential parameters
To add credentials in QRadar, log in as an
administrator and use Configuration Monitor on the
Risks tab.
|
Username
Password
Enable Password
|
|
Supported connection protocols
To add protocols in QRadar, log in as an administrator and use Configuration Monitor on the
Risks tab.
|
SSH
|
|
Backup operation commands that are issued by the adapter to the device
|
dmesgshow system power-supply
getmib
show access-list vlan <vlan id>
show access-list
show access-list <name or number>
show access-list ports <port number>
show config
show filter
show filter <id>
show running-config
show interfaces brief
show interfaces <interface id> For each interface.
show jumbos
show trunks
show lacp
show module
show snmp-server
show spanning-tree
show spanning-tree config
show spanning-tree instance <id or list> (for each
spanning-tree that is configured on the device)
show spanning-tree mst-config
show system information
show version
show vlans
show vlans <id> (for each vlan)
show vrrp
walkmib
|
|
show ip backup operation commands that are issued by the adapter to the
device
|
show ip
show ip route
show ip odpf
show ip odpf redistribute
show ip rip
show ip rip redistribute
|
|
Telemetry and neighbor data commands
|
getmib
show arp
show cdp neighbors
show cdp neighbors detail <port number>
show interfaces brief
show interface
show ip route
show lldp info remote-device
show lldp info remote-device <port number>
show mac-address or show mac address
show system information
show vlans
show vlans custom id state ipaddr ipmask
walkmib
|