This topic provides information about how to reset an I/O
processor while the system is running.
About this task
Resetting an IOP restarts and reloads that IOP. Use this
procedure to recover from an intermittent error condition.
Note: You
can also perform an IOP reset under the hardware service manager function
(see
Debug the resource).
Note: You cannot
reset the workstation IOP for the workstation at which you are working
or a workstation that is the only one on the system
Procedure
- Do you want to reset the local workstation IOP?
- Do you want to reset the communications IOP?
- Do you want to reset the cryptographic IOP?
- No: Continue with the next step.
- Yes: You must end cryptographic services. Enter
ENDCS
(End
Cryptographic Services) command. To reset the cryptographic IOP,
enter STRCS
Press F4 to prompt parameters. Then,
enter RESET *YES
. This ends the procedure.
- Do you want to reset a tape, optical, or disk IOP without
an attached disk unit?
- Yes: Continue with the next step.
- No: This ends the procedure.
- Vary off all the IOPs and device descriptions on the IOP
(see Varying configuration descriptions on and off).
- Enter the
VRYCFG
(Vary Configuration)
command. Then, press F4 for prompting.
- Enter
STATUS *ON
RESET *YES
Then,
press Enter. This ends the procedure.