Function 30: Service processor IP address and port location

This function displays the service processor IP address and port location. This function is available only in the manual operating mode and from power on standby.

Note: If IPv6 is displayed on the control panel, then the service processor's network ports are configured with IPv6 IP addresses. There are not enough characters on the control panel to display the entire address.

The following table shows an example of function 30.

Table 1. Function 30: Service processor IP address and port location
Function/Data Action or description 
3 0 _ _ _ _ _ _ _ _ _ _ _ _ _ _ 
_ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _
 Use the Increment or Decrement buttons to scroll to function 30. 
3 0 * * _ _ _ _ _ _ _ _ _ _ _ _
_ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _
 Press Enter to enter subfunction mode. 
3 0 0 0 _ _ _ _ _ _ _ _ _ _ _ _
_ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _
 Use the Increment or Decrement buttons to select an IP address
  • 00 = SP A: ETH0 (primary enclosure)
  • 01 = SP A: ETH1 (primary enclosure)
  • 02 = SP B: ETH0 (secondary enclosure)
  • 03 = SP B: ETH1 (secondary enclosure)
 
S P _ A : _ E T H O : _ _ _ T 5
9 . 5 . 1 0 5 . 2 4 3 _ _ _ _ _
 Press Enter to display the selected IP address. 
3 0 * * _ _ _ _ _ _ _ _ _ _ _ _
_ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _
 Use the Increment or Decrement buttons to select subfunction exit. 
3 0 _ _ _ _ _ _ _ _ _ _ _ _ _ _
_ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _
 Press Enter to exit subfunction mode.