Installing a part by using the HMC

You can use the Hardware Management Console (HMC) to perform many service actions, including the installation of a new feature or part.

1. In the navigation area, expand Systems Management > Servers.
2. Select the managed system on which you will install the part.
   Note: If your part is in a miscellaneous equipment specification (MES), continue with step 3. If your part is contained in the install done by the system services representative (SSR) or in a ship group, go to step 8.
3. In the Tasks area, expand Serviceability > Hardware > MES Tasks > Open MES.
4. Click Add MES Order Number.
5. Enter the number, and click OK.
6. Click the newly created order number, and click Next. The details of the order number are displayed.
7. Click Cancel to close the window.
8. In the Tasks area, expand Serviceability > Hardware > MES Tasks.
9. Select Add FRU (field replaceable unit).
10. In the Add/Install/Remove Hardware-Add FRU, Select FRU Type window, select the system or enclosure into which you are installing the feature.
11. Select the type of feature you are installing, and click Next.
12. Select the location code where you will install the feature, and click Add.
13. After the part is listed in the Pending Actions section, click Launch Procedure and follow the instructions to install the feature.
    Note: The HMC might open external instructions for installing the feature. If so, follow those instructions to install the feature.