RIO cable

Use this procedure to service the RIO cable.

1. The component will be serviced non-concurrently. Power should be removed from the unit. If this unit is powered on, power it off now. When the unit is completely powered off, disconnect the AC input source by removing the power cord from the unit. Do not apply power to the unit until directed to do so in this procedure.

2. Remove the RIO cable

   Release the RIO cable retainers. Disconnect the RIO cable(s).

3. Install the RIO cable

   Connect the RIO cable(s). Install the RIO cable retainers.

4. Verify the repair

   Go to Verification Procedures.