Installing a disk-drive filler

You might need to install a Small Computer System Interface (SCSI) disk-drive filler in the server or expansion unit. Use the procedure in this section to perform this task.

1. Attach the disk drive bezel (A) to the filler.
   Attention:

   • Attach a wrist strap to an unpainted metal surface of your hardware to prevent electrostatic discharge (ESD) from damaging your hardware.
   • When using a wrist strap, follow all electrical safety procedures. A wrist strap is for static control. It does not increase or decrease your risk of receiving electric shock when using or working on electrical equipment.
   • If you do not have a wrist strap, just prior to removing the product from ESD packaging and installing or replacing hardware, touch an unpainted metal surface of the system for a minimum of 5 seconds.
2. Press in and then tighten the thumbscrew (B) to secure the bezel to the disk drive.
3. Install the disk-drive bezel latch (C) onto the front of the filler, as shown in the figure.
   Figure 1. Attaching a bezel to a disk-drive filler

   
4. Install the disk-drive filler in the system or expansion unit, as shown in the following figure.
   Figure 2. Installing a disk-drive filler

   
5. Replace the front cover.
6. Install or close the system, expansion unit or rack front door.