Replacing the 5802 enclosure management controller

If you removed the enclosure management controller as part of another procedure, use the procedure in this section to replace the enclosure management controller.

To remove the enclosure management controller, see Removing the enclosure management controller.

If your system is managed by the Hardware Management Console (HMC), use the HMC to complete the steps for replacing the enclosure management controller in the server. For instructions, see Exchanging a part using the Hardware Management Console.

If you do not have an HMC, complete the following steps to replace the enclosure management controller:

Perform the prerequisite tasks as described in Before you begin.
Carefully slide the enclosure management controller into the system and close the latch (A) as shown in the following figure.
Figure 1. Replacing the enclosure management controller
Start the system. For instructions see, Starting the system or logical partition.
Verify the installed part. For instructions, see Verifying the installed part.