You might need to install the system into the rack. Use the procedure
in this section to perform this task.
To install the system into a rack, complete the following steps:
- Move to the back of the rack.
- If you are installing a drawer D into an
existing shell C, remove the two filler plate screws A and
the filler plate B.
| A |
Filler plate screws |
| B |
Filler plate |
| C |
Shell |
| D |
Drawer |
| E |
Drawer screws |
Figure 1. Removing the filler plate.
- Carefully move any existing cables that are blocking the drawer
location.
- Slide the drawer D into the shell.
- Install and tighten the two drawer screws E,
securing the drawer to the shell.
- If you are installing two drawers, repeat substeps 1 through 5.
If there is only one drawer installed in the shell, ensure that the filler
plate B is installed in the blank slot.
Subscribe to this information