This error code indicates that the service processor failed early
in its boot process.
Activate the service processor pinhole reset switch on the system's
operator panel.
Note: You must activate the service processor pinhole reset
switch very carefully. Using an insulated paper clip is recommended. Unbend
the clip so that it has a straight section about two inches long. Insert the
clip straight into the hole, keeping the clip perpendicular to the plastic
bezel. When you engage the reset switch, you should feel the detent of the
switch. After you press the switch, the service processor is reset, then the
system shuts down.
After activating the service processor pinhole reset switch, do
the following:
- Reboot the system in slow mode from the permanent side using operator
panel function 02.
- Is there an HMC attached to the system?
- NO
- Contact your service representative.
- YES
- Attempt to reflash the platform firmware from the HMC. If the reflash
is successful (the server boots to partition standby), that's the end this
procedure. If the reflash is not successful, go to step 3.
- Contact your service representative.
Subscribe to this information