Replace the control panel

You might need to remove the control panel from the server. Use the procedure in this section to perform this task.

1. Align the control panel C with its opening on the chassis.
   Figure 1. Replacing the control panel

   
2. Attach the control panel signal cable D to the back of the control panel C.
3. Push the control panel C in until it latches into place in the chassis.
4. Install the service access cover. Refer to Accessing the service access cover.
5. Install the front bezel.
6. Place the system in the operating position. Refer to Placing the system in the service or operating position.
7. Reconnect all system cables.
8. Start the system. Refer to Start the system or logical partition.
9. Verify the installed part. Refer to Verify the installed part.