POWER5 information.

Configuring a system port for call options

Configure a system port for use with the call-home and call-in options.

You can configure a system port used with the call-home and call-in features. You can also set the baud rate for a system port.

Note: Each system port is disabled when a Hardware Management Console (HMC) is attached to the server, and the server is booted beyond the service processor standby state. Therefore, these menus are not present if the system is managed by an HMC, or if the system has no ports.
To perform this operation, your authority level must be one of the following:
  • Administrator
  • Authorized service provider

To configure a system port, complete the following steps:

  1. In the navigation area, expand System Service Aids and click Serial Port Setup. Two sections are displayed. The first section is labeled S1, which is the system port that is used with the call-home feature. The second section is labeled S2, which is the system port that is used with the call-in feature.
  2. Modify the appropriate fields in the S1 and S2 sections.
    Baud rate
    Select the baud rate for this system port. If a terminal is attached to this port, the settings must match. The speeds available are 50, 300, 1200, 2400, 4800, 9600, 19200, 38400, 57600, and 115200 bps.
    Character size
    Select the character size for this system port. If a terminal is attached to this port, the settings must match.
    Stop bits
    Select the number of stop bits for this system port. If a terminal is attached to this port, the settings must match.
    Parity
    Select the parity for this system port. If a terminal is attached to this port, the settings must match.
  3. Click Save settings to save the setting changes.