Using the Emulator Configuration

To change an SNA configuration, use the following procedure:
  1. Select Configure from the Communication menu, then click Session Parameters.
  2. Change the parameters on this window as necessary and click OK.
  3. Click Link Parameters.

    Your default configuration file should be opened automatically. If you want to change a different configuration, click Existing and choose the configuration file you want to change.

    A wizard is displayed to prompt you through the configuration.

  4. Make your changes and then click Next.

    Now you can proceed through the wizard and make additional changes, if necessary.

  5. Click Finish when you are done.
  6. If you want to replace the existing configuration, click Yes to overwrite it. If you want to create a new configuration that is based on the existing one, type a new file name; however, you must use SNA Node Configuration to make a new configuration the default configuration.
  7. Click OK until you return to the session window.
Parent topic: Changing an SNA Configuration