Exiting OMEGAMON for IMS

You can exit an OMEGAMON for IMS Classic session in the OMEGAMON for IMS Classic address space, the OMEGAMON for IMS Classic interface, and the OMEGAMON® Subsystem.

Procedure

Perform the following procedures to exit OMEGAMON for IMS Classic.

Table 1. Tasks to complete to exit OMEGAMON for IMS Classic interfaces and applications.
To:	Configuration tasks
Stop the OMEGAMON for IMS Classic VTAM® applications	Issue the MODIFY command M0`imsid`,STOP=`cccccccc` where M0`imsid` is the mprefix that is concatenated to the IMSID specified in the OMEGAMON for IMS Classic startup proc, and `cccccccc` is the literal for VTAM. The OMEGAMON for IMS Classic VTAM interface stops. It is no longer possible to log on OMEGAMON through VTAM. The virtual terminal interface remains active after all the OMEGAMON for IMS Classic sessions end.
Stop the OMEGAMON for IMS Classic interface	Issue the MVS™ command MODIFY `stepname`,STOP where `stepname` is the name of the started procedure. The OMEGAMON for IMS Classic interface stops. Normally, you use KOIEPROC with EPILOG. Use KOIXPROC without EPILOG. Note: You can also issue commands to end IMS. When the interface detects that IMS is ended, the interface shuts down any OMEGAMON for IMS Classic sessions that are still active, and the OMEGAMON for IMS Classic address space ends. The OMEGAMON for IMS Classic interface remains active after all OMEGAMON for IMS Classic sessions end.
Stop the OMEGAMON Subsystem	You must not stop the OMEGAMON Subsystem unless you are certain that no other product uses it. The OMEGAMON Subsystem is designed to start and stop during the Initial Program Load (IPL) process. Multiple IBM® monitors on the same z/OS® image can use the OMEGAMON Subsystem. Note: To stop the OMEGAMON Subsystem, issue the `STOP` command from the operator console: `STOP IBMCN` where IBMCN is the name of the Subsystem startup procedure. The OMEGAMON Subsystem stops.