Restricting data types for selected report sets
Use the Data to Collect window to select the data types to be collected by the collect task for a specific report set.
About this task
Data Type field on the Trace
Configuration window, the Data to Collect window (Figure 1)
is displayed once for each selected report set that has more than one data
type.The Data to Collect window shown in Figure 1 uses an example for the Audit report set.
┌-------------------------------------------------------------------------┐
| DGOMAP31 Data to Collect Row 1 to 7 of 7 |
| |
| Task description . . . . . . : Collect data for acct/stats/audit |
| |
| Report |
| Set . . . : Audit |
| |
| Enter one or more selection characters to start Db2 traces for specific |
| data types or overtype with a blank to delete the selection. |
| |
| _ Select/Deselect all |
| |
| / Audited DDL Access |
| _ Audited DML Access |
| > Audited DML at Bind Access |
| _ Audited Utility Access |
| / Authorization Change |
| _ Authorization Control |
| _ Authorization Failures |
| -- End of Data Types -- |
| |
| Command ===> __________________________________________________________ |
| F1=Help F2=Split F3=Exit F7=Up F8=Down F9=Swap |
| F12=Cancel F16=Look |
└-------------------------------------------------------------------------┘
If you select the Select/Deselect all field,
all data type fields in this window are selected. If you type a blank in the Select/Deselect
all field, all selections are deleted.
Select the data types and press Enter to process the changes. Press Enter again to proceed to the next panel.