Verifying Near-Term History

Check the OMEGAMON Collector JESMSGLOG output to verify that the server accepted your parameters.

Before you begin

Before you test the setup for Near-Term History, make sure that you have completed the product setup, so that you can start the OMEGAMON® Collector.

Procedure

  1. Start the OMEGAMON Collector.
  2. In SDSF, open the JESMSGLG output of the OMEGAMON Collector started task.
  3. Review the JESMSGLG.
    You should see the output similar to the following:
     
    .
    .
    .
    KO2O1309I NEAR-TERM HISTORY DATA COLLECTOR SERVER KO2DMGRB 
    		IS ACTIVE (SERVINIE)
    KO2R0100I DRIVER INITIALIZED (CPINIT )
    KO2R0128I CAPTURING OUTPUT ON DATA SET 
    		SYS1PMO.V4.FULLTST.D824.RKD2VS03
    KO2R0105I SET STARTED - CONTSET1 D824 KO2O1309I 
    		NEAR-TERM HISTORY DATA COLLECTOR
    		SERVER KO2SSRVB IS ACTIVE (SERVINIE)
    KO2O1308I NEAR-TERM HISTORY DATA COLLECTOR ACTIVELY
    		MONITORING DB2 D824 (H2WLMGRE)
    .
    .
    .
     
     

    Messages KO2O1309I and KO2O1308I indicate that Near-Term History started successfully for the configured Db2® subsystems. Message KO2R0128I identifies the previously configured Near-Term History data sets.

  4. Review the SYSPRINT log.
    You should see the following message:
    KO2O1318I NEAR-TERM HISTORY DATA COLLECTOR - NEW OPTIONS 
    		IN EFFECT FOR CURRENT INTERVAL (NEWINOPT)