Topology Search error message partially rendered

Topology Search: error message only partially rendered into non-English languages.

Problem

This issue affects the Network Manager Insight® Pack 1.3.0.0. If you attempt to run a topology search between two nodes on the same device, the error message that is displayed is only partially rendered into non-English languages. The error message in full is as follows:

An error occurred calculating the path between 'X' and 'X',

The source and destination Node's cannot be the same

(Where X is the value of the NmosObjInst for the device. The first half of the message, An error occurred calculating the path between 'X' and 'X', is rendered into non-English languages. The second half of the message The source and destination Node's cannot be the same is not rendered into non-English languages and always appears in English.

Resolution

There is no workaround for this issue.