Running the probe in Console Mode

The way in which you run the probe depends on whether you are running the probe on a UNIX or Linux operating system, or on a Windows operating system.

If you are running the probe on a UNIX or a Linux operating system, start it using the following command:

$OMNIHOME/probes/nco_p_probename

Where nco_p_probename is the probe executable as listed in the Summary table of the probe's reference guide.

If you are running the probe on a Windows operating system, start it using the following command:

%OMNIHOME%\probes\win32\nco_p_probename

Where nco_p_probename is the probe executable as listed in the Summary table of the probe's reference guide.

Note: Because of a known issue, Windows probes can only be started from the %OMNIHOME%\probes\win32 directory.

For details about the options that you can specify for an individual probe, refer to its reference guide.