IBM integrations

Configuration

Before using the gateway, you must make various configuration settings.

Use this section to update any configuration settings that you need to make.

Flat File Gateway properties
You use the Flat File Gateway properties to specify how the gateway interfaces with the data source. You can override the default values by using the configuration file.
Startup command file
The startup command file contains a set of commands that the gateway executes each time it starts.
Table replication definition file
The gateway replicates data between ObjectServer tables and the gateway target. The table replication definition file is used to define which tables and event types are monitored in Tivoli Netcool/OMNIbus and forwarded to the target that the gateway is configured to send data to.
Mapping
Each gateway uses its own specific mapping.
Example configuration file
The following Flat File writer is supplied in the G_FILE.conf configuration file:
Running the gateway
This section describes how to run the Flat File Gateway.

Parent topic: Flat File