VLAN Commands

You can use the VLAN commands to configure the VLAN interfaces on the IBM® MQ Appliance.

The VLAN commands can be run from the command line interface in VLAN configuration mode. To enter VLAN configuration mode, complete the following steps:

From the appliance command line, enter global configuration mode:
```
config
```
From global configuration mode, enter Ethernet configuration mode:
```
vlan name
```
where name is the name of VLAN interface that you want to configure.
When you have finished, save your configuration:
```
write memory
```
Type exit to leave the configuration mode, then type exit again to leave global configuration mode.

VLAN interfaces are not supported for links used in high availability configurations or disaster recovery configurations.