Restoring a multi-instance integration node to the original version of IBM Integration Bus or WebSphere® Message Broker

You must complete a specific set of steps to restore your multi-instance integration node from IBM® Integration Bus Version 10.1 to the original version.

Before you begin

Read the topics in the section Performing in-place migration for an integration node (broker).

About this task

Use the following procedure to restore a multi-instance integration node to its original version.

You cannot use the mqsimigratecomponents command: only version-to-version migration is supported.

Procedure

  1. Stop the integration node on the standby node.
  2. Stop the integration node on the active node.
  3. On the active node, in an IBM Integration Bus Version 10.1 command console, run the following command:
    mqsistart BROKER1
  4. On the standby node, in an IBM Integration Bus Version 10.1 command console, run the following command:
    mqsistart BROKER1