FP= parameter for procedures
Use the FP= parameter in procedure to specify whether Fast Path is enabled. Valid values are N, and Y. The default is N.
You can only change the FP value at IMS cold start. If IMS is either warm started or emergency restarted with a different FP value, restart terminates.
The FP value must be the same on the active IMS system and the tracking system (XRF or FDBR). If the tracking system has a different FP value from the active system, it terminates.
- N
- Fast Path is not enabled. All other Fast Path execute parameters are ignored. This is the default. However, if FP=N, and you attempt to use a Fast Path resource or command, results are unpredictable.
- Y
- Fast Path is enabled.