DFS2594I NO CONTROL RECORD FOUND IN ddname RC=XX
Explanation
Program DBFDBDL0 attempted to load the MSDB image
copy from a data set. However it failed. The return code XX identifies
the problem:
- Code
- Meaning
- 01
- A data set does not contain an MSDB checkpoint or the checkpoint was incomplete.
- 02
- If the active system is taking the checkpoint, the alternate system cannot use the same MSDB checkpoint data set. This condition is temporary.
System action
The system takes action based on the return code:
- 01
- No MSDB copy is loaded, and the MSDBs cannot be used.
- 02
- The system rereads the MSDB data set every 3 seconds until it successfully reads.
Programmer response
Take action based on the return code:
- 01
- Make sure that the JCL is correct. Otherwise, restart IMS from another checkpoint data set, if possible, or run the MSDB recovery utility to create a new initial load data set, and restart the system with MSDBLOAD.
- 02
- The system rereads the checkpoint data set. If message RC=02 is issued only once, no response is required. If message RC=02 is issued more than once, check the status of active IMS. If active IMS is down, or an I/O error occurred on the MSDB checkpoint data set in active IMS, enter the /STOP BACKUP command to stop the alternate IMS.