DFS7413I ADJUSTED GLOBAL OTMA TPIPE COUNT IS nnnnnnn (FETP=xxxxxxx, BETP=yyyyyyy, WGF=zz%).

Explanation

The DFS7413I message is an additional informational message issued after global flood-related messages are issued, such as DFS4515W, DFS4516E, DFS4517I, DFS4385E, or DFS4386I. It shows the adjusted global tpipe count that is used for detecting global flood condition.

This message is issued only after the OTMA lightweight tpipe function is enabled by specifying LITETP=YES in the DFSYDTx member of the IMS.PROCLIB data set.

In the message text:
nnnnnnn
The adjusted global tpipe count that accounts for the less storage used by back-end tpipes.
This value is calculated as follows:
  • adjusted tpipe count = xxxxxxx + (yyyyyyy * zz)
xxxxxxx
The front-end tpipe count.
yyyyyyy
The back-end tpipe count.
zz
The percentage of the weighting factor in calculating the adjusted tpipe count for tpipe flood control.

System action

None.

Output destination

This message appears on the IMS master terminal and the write-to-operator (WTO) terminal.

Programmer response

No action is required.