Creating the control member

When using IMS HP Change Accumulation Utility in two-step batch mode, you must first create the control member for the HPCA-ID that was selected when you started the ISPF dialog.

The control member implements the parameters that were specified for that ID.

Complete the following steps to create the control information required for the two-step batch mode:

1. Use the ISPF user interface to specify the control information.
2. Run the BAT command to create the control member.
3. Exit the ISPF user interface.

Setting the control information for two-step batch mode is a one-time operation unless you must change any control parameters in the future.