NAMESWAPFAIL control statement
Specifies the action which the Smart Reorg utility takes when the IDCAMS program returns an error during name swapping.
This control statement is optional. This control statement is ignored unless NAMESWAP=YES is specified. The default is NAMESWAPFAIL=ABORT.
- ABORT
- The Smart Reorg utility ends abnormally without the
automated backout processing. After the Smart Reorg utility job, the manual backout processing is required by using the IDCAMS command stream produced in the
HPSGSWAP data set. Note: IBM® recommends that the HPSGSWAP data set is specified in the JCL stream.
- BACKOUT
- The Smart Reorg utility attempts the automated backout processing to restore the data set names to the names at the start of name swapping. After the backout processing, the DBRC flags, which are the READ ONLY flag and the PROHIBIT AUTHORIZATION flag, are also restored automatically to the original state.
- WTOR
- The Smart Reorg utility issues a message to request
the operator's action and reply. One of the following replies is allowed:
- CANCEL
- The behavior of the Smart Reorg utility is the same as NAMESWAPFAIL=ABORT.
- RETRY
- The Smart Reorg utility attempts to issue the failed IDCAMS command again and continue the name swap processing. Before this reply, the appropriate operation is needed to avoid another failure. The number of retries allowed is 10.
- BACKOUT
- The behavior of the Smart Reorg utility is the same as NAMESWAPFAIL=BACKOUT.