Allow Refresh While Active

Use this system parameter to enable or disable CDC Replication from refreshing a target table while changes are being made to the source table.

Versions supported—CDC Replication Engine for Db2® for i version 6.1 and later

After CDC Replication completes the refresh, it sends any remaining changes that were made on the source table during the refresh to the target table.

Applies to

Source datastores

Values

Set this parameter to one of the following values:

*YES: Enables CDC Replication to refresh the target table while there are active changes being made on the source table.
*NO: Disables CDC Replication from performing a refresh when there are active changes being made on the source table.

Default Setting

*YES