Setting system parameters on source and target datastores

A system parameter allows you to customize the behavior of CDC Replication.

About this task

You can specify system parameters for datastores in Management Console or modify system parameters on the replication servers by performing server-dependent operations. When you change the value of a system parameter for a particular source or target datastore, all users that have access to that datastore will see the change as well.

The default values for most system parameters should be adequate. However, depending on your requirements, you can modify the a system parameter to specify a behavior for CDC Replication that is different than the default.

Procedure

  1. Click Configuration > Datastores.
  2. Right-click on a datastore and select Properties.
  3. Click Add on the System Parameters tab.
  4. Enter the name of the parameter in the Parameter Name box.
  5. Enter the value in the Value box.
  6. Click OK.

Modifying system parameters

Procedure

  1. Click Configuration > Datastores.
  2. Right-click on a datastore and select Properties.
  3. Select a system parameter on the System Parameters tab.
  4. Click Modify.
  5. Enter a value in the Value box.
  6. Click OK.

Deleting system parameters

Procedure

  1. Click Configuration > Datastores.
  2. Right-click on a datastore and select Properties.
  3. Select a system parameter on the System Parameters tab.
  4. Click Delete.