Displaying incorrect Licensed Internal Code installation

When the Licensed Internal Code is restored on a mirrored unit for unit 1, one of the mirrored units might have the incorrect level of data stored on it.

If this condition occurs, and the disk unit that contains the correct data is not available, the Licensed Internal Code is restored to the disk unit with the incorrect data. When a disk preforms an initial program load (IPL) and the correct disk unit is available, the following display is shown. If the keylock switch is not in the Manual position, system reference code (SRC) is shown on the control panel for the system or logical partition.

              Display Incorrect Licensed Internal Code Install
 
Licensed Internal Code has been installed on the incorrect
disk unit of the load source mirrored pair.
 
If you continue the IPL, the previously installed Licensed Internal
Code installed on the incorrect disk unit of the mirrored
load source pair will be deleted.  The Licensed Internal Code
will be replaced by the Licensed Internal Code from the correct
disk unit.
 
The following disk unit is the correct disk unit.
 
Disk unit:
  Type  . . . . . . . . . . . . . .  . . . :     6602
  Model   . .  . . . . . . . . . . . . . . :     030
  Serial number. . . . . . . . . . . . . . :     00-0163477_
  Resource name  . . . . . . . . . . . . . :     DD019
 
Press Enter to continue.