Checklist for applying service
Table 1 lists the steps and associated VMSES/E commands for installing corrective service on High Level Assembler. You can use Table 1 as a checklist.
| Step | Description | VMSES/E Command | Topic |
|---|---|---|---|
| __ 1 | Prepare to install service. | Step 1. Prepare to install service | |
| __ 2 | Clear the alternate APPLY disk. Doing this will allow you to remove the new service easily later if necessary. | VMFMRDSK | Step 2. Clear the alternate APPLY disk |
| __ 3 | Receive the new service. | VMFREC | Step 3. Receive the new service |
| __ 4 | Apply the new service. | VMFAPPLY | Step 4. Apply the new service |
| __ 5 | Reapply local service by entering local service into the software inventory (if applicable). | Step 5. Reapply local service | |
| __ 6 | Update Build Status Table. | VMFBLD | Step 6. Update build status table |
| __ 7 | Rebuild Serviced Parts (objects). | VMFBLD | Step 7. Rebuild serviced parts (objects) |
| __ 8 | Verify the service that has been applied and built. | Step 8. Verify the service | |
| __ 9 | Place the service into production. | Step 9. Place the service into production |