enable_health_analyzer

This command enables the disk and database health analyzer.

By default, the analyzer sends alerts when the system predicts that the database size or files on a disk (/var) will reach 50% in the next 14 days. When enabled, it runs at a predefined schedule with a start time of 05:07:07. The schedule resets any time the health analyzer is enabled or re-enabled.

This API is available in Guardium V10.6 and later.

REST API syntax

This API is available as a REST service with the PUT method. Call this API as follows: 
PUT https://[Guardium hostname or IP address]:8443/restAPI/enableHealthAnalyzer

GuardAPI syntax

enable_health_analyzer parameter=value

Parameters

Parameter Value type Description
api_target_host String

Specifies the target hosts where the API executes. Valid values:
  • all_managed: execute on all managed units but not the central manager
  • all: execute on all managed units and the central manager
  • group:<group name>: execute on all managed units identified by <group name>
  • host name or IP address of a managed unit: specified from the central manager to execute on a managed unit.  For example, api_target_host=10.0.1.123.
  • host name or IP address of the central manager: specified from a managed unit to execute on the central manager. For example, api_target_host=10.0.1.123.

IP addresses must conform to the IP mode of your network. For dual IP mode, use the same IP protocol with which the managed unit is registered with the central manager. For example, if the registration uses IPv6, specify an IPv6 address. The hostname is independent of IP mode and can be used with any mode.

Examples

Use this command to enable the disk and database health analyzer:

grdapi enable_health_analyzer