disable_threat_detection_use_case

Use this command to remove use case types from the threat detection analysis.

This API is available in Guardium V10.1.4 and later.

REST API syntax

This API is available as a REST service with the POST method. Call this API as follows: 
POST https://[Guardium hostname or IP address]:8443/restAPI/disable_threat_detection_use_case

GuardAPI syntax

disable_threat_detection_use_case parameter=value

Parameters

Parameter Value type Description
case_name String Required. For valid values, call disable_threat_detection_use_case from the command line with --help=true.
api_target_host String

Specifies the target hosts where the API executes. Valid values:
  • all_managed: execute on all managed units but not the central manager
  • all: execute on all managed units and the central manager
  • group:<group name>: execute on all managed units identified by <group name>
  • host name or IP address of a managed unit: specified from the central manager to execute on a managed unit.  For example, api_target_host=10.0.1.123.
  • host name or IP address of the central manager: specified from a managed unit to execute on the central manager. For example, api_target_host=10.0.1.123.

IP addresses must conform to the IP mode of your network. For dual IP mode, use the same IP protocol with which the managed unit is registered with the central manager. For example, if the registration uses IPv6, specify an IPv6 address. The hostname is independent of IP mode and can be used with any mode.

Examples

To remove the grants use case from the threat detection analysis:

grdapi disable_threat_detection_use_case case_name=GRANTS