Run on a central manager to disable outliers on the collector(s) that send data to the specified aggregator(s). This is for use in a multi-central manager environment; the aggregator is in this central manager's environment but the collectors are managed by a different central manager.

This API is available in Guardium V10.6 and later.

REST API syntax

This API is available as a REST service with the PUT method. Call this API as follows:
PUT https://[Guardium hostname or IP address]:8443/restAPI/disableOutliersDetectionOnAggCrossCm

GuardAPI syntax

disable_outliers_detection_cross_cm_agg parameter=value


Parameter Value type Description
aggregator_host_name String Required.
api_target_host String

Specifies the target hosts where the API executes. Valid values:
  • all_managed: execute on all managed units but not the central manager
  • all: execute on all managed units and the central manager
  • group:<group name>: execute on all managed units identified by <group name>
  • host name or IP address of a managed unit: specified from the central manager to execute on a managed unit.  For example, api_target_host=
  • host name or IP address of the central manager: specified from a managed unit to execute on the central manager. For example, api_target_host=

IP addresses must conform to the IP mode of your network. For dual IP mode, use the same IP protocol with which the managed unit is registered with the central manager. For example, if the registration uses IPv6, specify an IPv6 address. The hostname is independent of IP mode and can be used with any mode.


To disable outliers on the collectors that send data to the aggregator agg12, run this command on the CM that the aggregator agg12 reports to:

disable_outliers_detection_cross_cm_agg aggregator_host_name=agg12