change_tracker_get_params

Display the parameters for a specified change tracker task.

For use by IBM Guardium support only.

This API is available in Guardium V10.1.4 and later.

REST API syntax

This API is available as a REST service with the GET method. Call this API as follows:
GET https://[Guardium hostname or IP address]:8443/restAPI/change_tracker_get_params

GuardAPI syntax

change_tracker_get_params parameter=value

Parameters

Parameter Value type Description
paramName String The name of the parameter that you want to view.
task String A task for which you want to view the parameter names and values. For a list of available tasks, use the change_tracker_get_tasks API.
api_target_host String

Specifies the target hosts where the API executes. Valid values:
  • all_managed: execute on all managed units but not the central manager
  • all: execute on all managed units and the central manager
  • group:<group name>: execute on all managed units identified by <group name>
  • host name or IP address of a managed unit: specified from the central manager to execute on a managed unit.  For example, api_target_host=10.0.1.123.
  • host name or IP address of the central manager: specified from a managed unit to execute on the central manager. For example, api_target_host=10.0.1.123.

IP addresses must conform to the IP mode of your network. For dual IP mode, use the same IP protocol with which the managed unit is registered with the central manager. For example, if the registration uses IPv6, specify an IPv6 address. The hostname is independent of IP mode and can be used with any mode.

Example

grdapi change_tracker_get_params
ID=0
[
  {
        "task":"CORE",
        "taskParams":[
                                {"paramName":"CHANGE_TRACKER_ENABLED",
                                 "paramValues":[
                                                {"paramValue":"1"}
                                ]},
                                {"paramName":"CHANGE_TRACKER_MSG_QUEUE_SCAN_INTERVAL",
                                 "paramValues":[
                                                {"paramValue":"10"}
                                ]},
                                {"paramName":"CHANGE_TRACKER_MSG_QUEUE_CLEANSER_INTERVAL",
                                 "paramValues":[
                                                {"paramValue":"30"}
                                ]},
          . . .
  ]},
  {
        "task":"UNIT_PROPERTIES",
        "taskParams":[
                                {"paramName":"RUN_INTERVAL",
                                 "paramValues":[
                                                {"paramValue":"300"}
                                ]}
  ]},
  {
        "task":"STAP_PROPERTIES",
        "taskParams":[
                                {"paramName":"RUN_INTERVAL",
                                 "paramValues":[
                                                {"paramValue":"300"}
                                ]}
  ]},

. . .
ok