revoke_ignore_stap

This command revokes existing IGNORE S-TAP SESSION (REVOKABLE) policy rule actions that ignore S-TAP® session traffic. This command only revokes soft ignore rules (marked as REVOKABLE) and cannot revoke hard rules (not marked as REVOKABLE).

This API is available in Guardium V9.5 and later.

REST API syntax

This API is available as a REST service with the POST method. Call this API as follows: 
POST https://[Guardium hostname or IP address]:8443/restAPI/revoke_ignore_stap

GuardAPI syntax

revoke_ignore_stap parameter=value

Parameters

Parameter Value type Description
stapHost String For valid values, call revoke_ignore_stap from the command line with --help=true.
api_target_host String

Specifies the target hosts where the API executes. Valid values:
  • all_managed: execute on all managed units but not the central manager
  • all: execute on all managed units and the central manager
  • group:<group name>: execute on all managed units identified by <group name>
  • host name or IP address of a managed unit: specified from the central manager to execute on a managed unit.  For example, api_target_host=10.0.1.123.
  • host name or IP address of the central manager: specified from a managed unit to execute on the central manager. For example, api_target_host=10.0.1.123.

IP addresses must conform to the IP mode of your network. For dual IP mode, use the same IP protocol with which the managed unit is registered with the central manager. For example, if the registration uses IPv6, specify an IPv6 address. The hostname is independent of IP mode and can be used with any mode.

Examples

grdapi revoke_ignore_stap