delete_invalid_stap

Use this command to remove invalid S-TAPs from the Deployment Health Topology view, for example. This command deletes invalid S-TAPs, and not inactive S-TAPs.

This API is available in Guardium V10.6 and later.

GuardAPI syntax

delete_invalid_stap parameter=value

Parameters

Parameter Value type Description
api_target_host String

Specifies the target hosts where the API executes. Valid values:
  • all_managed: execute on all managed units but not the central manager
  • all: execute on all managed units and the central manager
  • group:<group name>: execute on all managed units identified by <group name>
  • host name or IP address of a managed unit: specified from the central manager to execute on a managed unit.  For example, api_target_host=10.0.1.123.
  • host name or IP address of the central manager: specified from a managed unit to execute on the central manager. For example, api_target_host=10.0.1.123.

IP addresses must conform to the IP mode of your network. For dual IP mode, use the same IP protocol with which the managed unit is registered with the central manager. For example, if the registration uses IPv6, specify an IPv6 address. The hostname is independent of IP mode and can be used with any mode.

Examples

To delete invalid S-TAPs from a collector:
grdapi delete_invalid_stap debug=3
To delete invalid S-TAPs from the collector XXXX, enter this command on the collector's central manager:
grdapi delete_invalid_stap api_target_host=XXXX debug=3
To delete all invalid S-TAPs from in a centralized system, enter this command on the central manager:
grdapi delete_invalid_stap api_target_host=all debug=3