Guardium Hosts (SQLGuard) parameters
These parameters describe a Guardium system to which this S-TAP can connect. All parameters in this section are basic, and appear in the [SQL_GUARD] section.
Attention: If a parameter is available through both the GIM and the command
line interface (CLI), then the GIM parameter,
including any defaults, always overwrites any value that is available from
WINSTAP_CMD_LINE.
| GUI | GIM | guard_tap.ini | Default value | Description | Protocol version |
|---|---|---|---|---|---|
 (checkmark indicates the primary host) |
PRIMARY | Indicates the primary Guardium system for this S-TAP. In guard_tap.ini: 0=secondary, 1=primary | 7 and 8 | ||
| TAP_GUARD_TCP_PORT | 9500 | Read only. Port used for S-TAP to connect to Guardium system. | 7 | ||
| TAP_GUARD_TCP_PORT | 9800 | Read only. Port used for S-TAP to connect to Guardium system. | 8 | ||
| Guardium Host | WINSTAP_SQLGUARD_IP | SQLGUARD_IP | NULL | IP address or hostname of the Guardium system that acts as the host for the
S-TAP. You can define multiple hosts by adding [SQLGuard_1], [SQLGuard_2], and so on. SQLGUARD_IP and SOFTWARE_TAP_HOST must be both either IPv4 or IPv6. Do not mix IP modes for these addresses. |
7 and 8 |