reregister_agg_collector

Use this command to un-register a collector from its current aggregator, and register it with the specified aggregator.

This API is available in Guardium V10.1.4 and later.

GuardAPI syntax

reregister_agg_collector parameter=value

Parameters

Parameter Value type Description
newDomain String The domain name of the new host.
newHostName String Required. Aggregator you are registering the collector with.
api_target_host String

Specifies the target hosts where the API executes. Valid values:
  • all_managed: execute on all managed units but not the central manager
  • all: execute on all managed units and the central manager
  • group:<group name>: execute on all managed units identified by <group name>
  • host name or IP address of a managed unit: specified from the central manager to execute on a managed unit.  For example, api_target_host=10.0.1.123.
  • host name or IP address of the central manager: specified from a managed unit to execute on the central manager. For example, api_target_host=10.0.1.123.

IP addresses must conform to the IP mode of your network. For dual IP mode, use the same IP protocol with which the managed unit is registered with the central manager. For example, if the registration uses IPv6, specify an IPv6 address. The hostname is independent of IP mode and can be used with any mode.

Examples

To reregister the aggregator with the collector named coll44:

grdapi reregister_agg_collector newHostName=coll44