list_stap_verification_results

This API returns the details and the verification results for each S-TAP® that reports to the specified Guardium® system.

This GuardAPI is available in Guardium V9.5 and later.

The REST API is available in Guardium V11.1 and later.

REST API syntax

This API is available as a REST service with the GET method. Call this API as follows: 
GET https://[Guardium hostname or IP address]:8443/restAPI/list_stap_verification_results

GuardAPI syntax

list_stap_verification_results parameter=value

Parameters

Parameter Value type Description
stapHost String  
api_target_host String

Specifies the target hosts where the API executes. Valid values:
  • all_managed: execute on all managed units but not the central manager
  • all: execute on all managed units and the central manager
  • group:<group name>: execute on all managed units identified by <group name>
  • host name or IP address of a managed unit: specified from the central manager to execute on a managed unit.  For example, api_target_host=10.0.1.123.
  • host name or IP address of the central manager: specified from a managed unit to execute on the central manager. For example, api_target_host=10.0.1.123.

IP addresses must conform to the IP mode of your network. For dual IP mode, use the same IP protocol with which the managed unit is registered with the central manager. For example, if the registration uses IPv6, specify an IPv6 address. The hostname is independent of IP mode and can be used with any mode.

Examples

To return the verification status of the S-TAPs reporting to this Guardium system

grdapi list_stap_verification_results
         S-TAP Host = 9.42.29.158
         Protocol = oracle
         Port Range = 1521-1521
         Inspection Engine Identifier = oracle_9.42.29.158(1521,1521,DB_0)
         Verification Status = Unverified

         S-TAP Host = 9.42.29.158
         Protocol = mysql
         Port Range = 3357-33060
         Inspection Engine Identifier = mysql_9.42.29.158(3357,33060,DB_2)
         Verification Status = Unverified

         S-TAP Host = 9.42.29.158
         Protocol = db2
         Port Range = 50000-50000
         Inspection Engine Identifier = db2_9.42.29.158(50000,50000,DB_3)
         Verification Status = Unverified