clone_cas_template_set

This command creates a clone of an existing Configuration Auditing System (CAS) template set.

This API is available in Guardium V9.5 and later.

REST API syntax

This API is available as a REST service with the POST method. Call this API as follows: 
POST https://[Guardium hostname or IP address]:8443/restAPI/clone_cas_template_set

GuardAPI syntax

clone_cas_template_set parameter=value

Parameters

Parameter Value type Description
clonedTemplateSetLabel String Required. The name of the new template set.
templateSetLabel String Required. The name of the existing template set that you want to clone.
api_target_host String

Specifies the target hosts where the API executes. Valid values:
  • all_managed: execute on all managed units but not the central manager
  • all: execute on all managed units and the central manager
  • group:<group name>: execute on all managed units identified by <group name>
  • host name or IP address of a managed unit: specified from the central manager to execute on a managed unit.  For example, api_target_host=10.0.1.123.
  • host name or IP address of the central manager: specified from a managed unit to execute on the central manager. For example, api_target_host=10.0.1.123.

IP addresses must conform to the IP mode of your network. For dual IP mode, use the same IP protocol with which the managed unit is registered with the central manager. For example, if the registration uses IPv6, specify an IPv6 address. The hostname is independent of IP mode and can be used with any mode.