Identify network ports
Use the following CLI commands to map the network ports.
show network interface inventory
Use this CLI command to display the port names and MAC addresses of all installed network interfaces.
show network interface inventory
Current network card configuration:
Device | Mac Address | Member of
----------------------------------------------------------------------
ens4f1np1 | 84:16:0C:AA:36:ED | br3
ens4f2np2 | 84:16:0C:AA:36:EE | br4
ens4f3np3 | 84:16:0C:AA:36:EF | br5
ens2f1 | B4:96:91:F7:D1:6D. | br1
ens4f0np0 | 84:16:0C:AA:36:EC. |
ens2f0 | B4:96:91:F7:D1:6C |br0
ok
show network interface role
Use this CLI command to display the network port that is assigned as the primary port.
show network interface role
Device: Role:
ens2f0 bridgemember
ens2f1 bridgemember
ens4f0np0 primary
ens4f1np1 bridgemember
ens4f2np2 bridgemember
ens4f3np3 bridgemember
br3 –
br4 –
br5 –
br1 –
br0 –
okThe port ens4f0np0 is assigned as the primary port.
show network interface port
This command flashes the light 20 times on the physical port. Use this CLI
command to locate a physical connector on the back of the appliance.
show network interface port ens4f0np0Install the software directly on a dedicated computer
When you install the Guardium software directly to disk on a dedicated computer, use the Physical appliance instructions.