Adding a node to an installer-provisioned infrastructure

Add nodes to increase storage capacity for Fusion Data Foundation to an installer-provisioned infrastructure when existing worker nodes reached the maximum supported OSDs or when resources are insufficient to add new OSDs on existing nodes.

Before you begin

You are logged in to the Red Hat® OpenShift® Container Platform web console as an administrator.
Fusion Data Foundation service is installed and configured.
It is recommended to add nodes in multiples of three, placing each node in a different failure domain or zone. Repeat this procedure for each node. For bare metal installer-provisioned infrastructure, expand the cluster before proceeding.

While adding nodes in multiples of three is recommended, you can still add one node at a time in a flexible scaling deployment. To verify whether flexible scaling is enabled, see Red Hat Knowledgebase article Scaling OpenShift Data Foundation cluster using YAML when flexible scaling is enabled.

Important: Fusion Data Foundation does not support heterogeneous disk size and types. Add only nodes with disks that match the type and size that is used during the initial deployment.

Procedure

Go to Compute > MachineSets.
On the MachineSets page, select Edit Machine Count from the Action Menu (⋮) of the machine set where you want to add nodes.
Specify the number of nodes to add, and click Save.
Click Compute > Nodes and verify that the new node is in Ready state.
Apply the Fusion Data Foundation label to the new node.x
1. Click the Action Menu (⋮) for the new node and select Edit labels.
2. Add the cluster.ocs.openshift.io/openshift-storage label and click Save.
Do the following verification steps:
1. Run the following command and verify that the new node is present in the command output:
  Command example:
```
oc get nodes --show-labels | grep cluster.ocs.openshift.io/openshift-storage= |cut -d' ' -f1
```
  Output example:
```
r8-ru10-w-1.stg-odf-211.fusion.tadn.ibm.com
r8-ru12-w-1.stg-odf-211.fusion.tadn.ibm.com
r8-ru14-w-1.stg-odf-211.fusion.tadn.ibm.com
r8-ru8-w-1.stg-odf-211.fusion.tadn.ibm.com
```
2. Go to Workloads > Pods and check that the following Pods on the new node are in the Running state:
  - openshift-storage.cephfs.csi.ceph.com-*
  - openshift-storage.rbd.csi.ceph.com-*

Results

Additional nodes are added to the infrastructure and are available for use in the Fusion Data Foundation cluster.

What to do next

Scale up the storage capacity by following the instructions mentioned in Scaling up storage capacity.