BMYCO0006

Any critical set failures.

Severity

Critical

Error conditions

The error message can be for the following conditions:
  • Unable to change first time password
  • Configuring IPv6 address failed with output
  • IMM's new IPv6 address configured is not reachable - Onecli config set failed with output (Boot order and System Boot Mode)
  • Onecli failed to clear SysInfoProdIdentifier for SR645 with output
  • Onecli failed to set Processors.PreferredIOBus=Preferred
  • Onecli failed to set Processors.PreferredIOBusNumber
  • Configuring ports failed with output
  • Configuring alertentries failed with output
  • Configuring power restoration policy failed
  • Configuring snmp failed
  • Configuring snmpAlerts failed with output
  • Configuring password complexity failed with output
  • Adding user %s failed with output
  • Clearing existing raid config failed for controller
  • Unable to config drv mkgood for node
  • Unable to config drive mkgood for node
  • Error clearing mvstor for node
  • Configuring disks in raid mode failed with output
  • Configuring disks in raid mode failed with output
  • Enabling IPMI over VLAN failed with output
  • Onecli config set failed with output (Settling Network Link Type to Ethernet)
  • Failed to set Mellanox Network Adapter NetworkLinkType to Ethernet
Note: All of the error conditions have built-in retries. However, there shall be support tickets to check the appliance if the event persists for a longer duration. If the condition is transient, it recovers automatically. Otherwise, IBM Support checks the appliance.

User response

Do the following steps to diagnose the error:
  1. If you have enabled Call Home feature, then the system automatically collects compute collection set logs and raises a Call Home ticket.
  2. If you have not enabled Call Home feature, collect the Nodes logs and contact IBM support .