Verifying correct operation of system

About this task

Complete the following steps to verify the correct operation of the device.

Procedure

switch:admin> login
login: admin
password: xxxxxxxx
switch:admin>

Enter the chassisShow command to verify that airflow direction set on WWN cards matches airflow direction for fans in fan and power supply assemblies installed in device. Airflow direction of fans and power supplies displays as "Fan Direction" under each fan or power supply unit. System airflow direction displays as "System Airflow" under the WWN card unit. The following example shows mismatch of system airflow and airflow direction in installed fan and power supply.
```
POWER SUPPLY  Unit: 1
Power Source:           AC
Fan Direction:          Non-portside Intake
...
FAN  Unit: 2
Fan Direction:          Non-portside Intake
...
WWN  Unit: 1
System AirFlow:         Non-portside Exhaust
...
WWN  Unit: 2
System AirFlow:         Non-portside Exhaust
```
The WWN units should indicate "Non-portside Intake." If there is a mismatch of airflow direction, RAS log messages will indicate a mismatch between system airflow direction and airflow direction of fan in power supply or fan assembly refer to the Hardware Installation Guide for your product for more details.

Verify that the device is functioning correctly by entering switchShow or switchStatusShow.

This switchShow command displays the device and port status information.

switch0:admin> switchshow
switchName:     sw0
switchType:     165.0
switchState:    Online
switchMode:     Native
switchRole:     Principal
switchDomain:   130
switchId:       fffc82
switchWwn:      10:00:00:05:31:03:2c:00
zoning:         ON (ZONE_CONFIG_NAME)
switchBeacon:   OFF
FC Router:      OFF
HIF Mode:       OFF
Allow XISL Use: OFF
LS Attributes:  [FID: 128, Base Switch: No, Default Switch: Yes, 
Address Mode 0]
Index Slot Port Address Media  Speed  State    Proto
=======================================================
  64    4    0   014000   --    N32   Online   FC  F-Port  10:00:00:05:1e:f8:a0:b4
  65    4    1   014100   --    N32   Online   FC  F-Port  10:00:00:05:33:26:0e:65
  66    4    2   014200   --    N32   Online   FC  F-Port  10:00:00:05:33:48:5e:f5
  67    4    3   014300   --    N32   Online   FC  F-Port  10:00:00:05:1e:f8:a0:b3
  68    4    4   014400   --    N32   Online   FC  F-Port  10:00:00:05:1e:f8:a0:b6
(output truncated)

Verify that all the IP address information is correct by entering ipAddrShow and checking the results against the IP information recorded in the config-miscinfo.txt file.
```
switch:admin> ipaddrshow

SWITCH
Ethernet IP Address: 14.25.60.14
Ethernet Subnetmask: 255.55.0.0
Gateway IP Address: 14.25.43.1
DHCP: Off
```