4100 Remote command failure during replication configuration

Explanation

This error can occur when the system runs commands on the remote system to configure policy-based replication and these commands fail because of configuration problem on the remote system.

User response

Run the fix procedure for this error in the management GUI to resolve any issues on the remote system. The fix procedure displays the error message and also shows the information about the command that failed on the remote system. The underlying issue that caused this failure must be resolved before replication can resume.
The following is a list of the error messages that can be associated with this remote failure, and the remedial action associated with each. Errors during certificate actions:
CMMVC1656E - The command failed because certificate signing request for partition certificate was not created on the remote site.
  • Perform the manual fix as prompted in the event log.
  • If the event reoccurs, apply the following service actions:
    • For system signed or externally signed certificate installed, remove the certificate using rmpartitioncertstore command.
    • For certificate signing request in installed_pending, cancel the certificate signing request using chpartitioncertstore command. If the cancel command failed on the remote (non-AMS) system, then manually run the chsystemcertstore cancel command on the remote system.
CMMVC1657E - The action failed because OpenSSL CMS encryption fails for certificate and private key.
Refer CMMVC1656E error message for action.
CMMVC1658E - The command failed because OpenSSL CMS encryption fails for CSR and private key.
Refer CMMVC1656E error message for action.
CMMVC1659E - The command failed because REST API call fails to send encrypted bundle to remote.
Refer CMMVC1656E error message for action.
CMMVC1660E - The command failed because system failed to decrypt and install the encrypted bundle to remote.
Refer CMMVC1656E error message for action.
CMMVC1662E - The command failed because partition certificate was not removed on the remote site.
  • Perform the manual fix suggested by the system event.
  • If the event reappears, manually remove the certificate from the remote (non‑AMS) system using rmpartitioncertstore command or remove it via the GUI certificate workflow.