Preparing the slide assemblies

Perform the following steps to prepare both slide assemblies for installation.

1. Locate the slide assembly in the kit, as shown in the following figure. The slide assembly comes fully assembled and includes all of the parts shown in the figure.
2. Pull the inner slide rail out until the lock engages. Refer to the following figure.
3. Press the lock-release lever located inside the inner slide rail and pull the inner rail away from the outer rail.
4. Repeat these steps for the second slide assembly.
   Note: The device must be turned off and disconnected from the fabric during the installation procedure.
   Figure 1. Pulling the slide rails apart

   

   • 1. Inner slide rail
   • 2. Lock-release lever
   • 3. Slide assembly