Installing the device in the rack

About this task

Complete the following steps to install the device in the rack.

Position the device in the rack, as shown in the following figure, providing temporary support under the device until the rail kit is secured to the rack.
Attach the right front bracket to the right front rack post using two 10-32 x 5/8-in. screws and two retainer nuts.
Attach the left front bracket to the left front rack post using two 10-32 x 5/8-in. screws and two retainer nuts.
Tighten all the 10-32 x 5/8-in. screws to a torque of 25 in-lbs (29 cm-kgs)
Figure 1. Positioning the device in the rack
- 1. Bracket, front left
- 2. Bracket, front right
- 3. Retainer nut, 10-32
- 4. Screw, 10-32 x 5/8-in., panhead Phillips
Note: The figure above is shown with a recessed mounting configuration on the left and a flush mounting configuration on the right. You can select either mounting option.

Note: Install the device with the airflow aligned with any other devices in the rack. Some devices have airflow running from port side to fan side and others have the opposite arrangement. Make sure that the airflow for all devices moves in the same direction to maximize cooling. Refer to the Hardware Installation Guide for your product for specific requirements.